Scheduling•3 min read

Overtime Management

Spot overtime before the schedule goes out, and see what was actually worked.

How SimpleStaff Helps With Overtime

Overtime is cheapest to fix before the schedule goes out. SimpleStaff gives you three tools for that: warnings while you build the week, a hard cap on hours where you need one, and reports and payroll for the hours people actually worked.

The Tools

Overtime Alerts (Team plan)

Set the weekly hours where overtime starts and where the warning begins. Names on the schedule get a "Near OT" or "OT +4h" chip, and the open-shift picker warns before an assignment would push someone over. Alerts warn and never block.

Max Hours (Team plan)

A cap on how many hours each person can be scheduled in a week, set by employment type. You can choose to block assignments that would go over it. Use this when overtime simply isn't allowed.

Reports and Payroll

Reports show overtime hours worked. Payroll (Pro plan) splits each person's hours into regular, overtime and double-time pay using your payroll overtime settings, including daily overtime if you set it.

To turn on and configure Overtime Alerts, see Overtime Limits.

While You Build the Schedule

  • • Each person's row shows their paid scheduled hours for the week. Unpaid breaks aren't counted.
  • • With Overtime Alerts on, an amber "Near OT" chip appears once someone reaches your warning point, and an orange "OT +4h" chip once they're past the overtime line.
  • • With Max Hours on, the hours turn amber near the cap and red over it.
  • • Salaried staff and anyone marked not eligible for overtime on their profile aren't flagged for overtime.

Your Overtime Rules

When overtime starts depends on your province and any collective agreement. Ontario, for example, uses 44 hours a week. Payroll can pay weekly overtime, daily overtime and daily double time. Overtime Alerts on the schedule still count by the week, so if your rules have daily overtime, watch long shifts while you build the week.

Always verify overtime rules with your local labor authority. This is general guidance only.

Daily Overtime and Double Time in Payroll

  • • In payroll settings, set Daily hours before overtime and, if you need it, Daily hours before double time. Leave both blank to keep weekly overtime only.
  • • Use British Columbia rules fills in the numbers from BC's Employment Standards Act: overtime after 8 hours a day and 40 hours a week at 1.5×, double time after 12 hours a day, and a work week that starts on Sunday.
  • • Weekly overtime counts only the hours that weren't already paid as daily overtime, so no hour is paid twice. Five 10-hour days is 40 regular hours and 10 overtime hours.
  • • A shift that runs past midnight counts as one day, starting when the shift starts. A 7 pm to 7 am night is one 12-hour day: 8 regular hours and 4 overtime hours.
  • • Double time has its own column on the pay run, its own line on paystubs, and its own earning code in the payroll export (DT unless you change it).
  • • Salaried staff and anyone marked not eligible for overtime are paid straight time for every hour.
  • • The BC numbers don't cover averaging agreements or a collective agreement's own overtime terms. If an agreement applies, set the numbers to match it.

Best Practices

Use the same number everywhere

Set the Overtime Alerts line to match your payroll overtime setting, so what the schedule warns about is what payroll pays.

Cap hours where overtime isn't an option

Set Max Hours at or below the overtime line for staff who should never go over. Auto-fill (Pro plan) never schedules anyone past their max and spreads hours evenly within a group.

Check before you publish

Scan the schedule for OT chips before publishing the week. Moving one shift is easier than paying for it.

Need help with overtime settings?

Contact Support